Here are briefly described general principle for usage of Free Energy and some consequenes of applications, valid for engines using Free Energy of diverse kind.
Third kind
Well known are definitions of Perpetuum Mobile of first and second kind, by which is documented, no energy earning is possible. By following definitions of Perpetuum Mobile third kind is described, how to produce usable energy by Free Energy.
Free Energy
Free Energy is available in different shapes and its forces permanently produce effects. Here are noticed only some forms of Free Energy.
There is gravity, which pulls each mass in direction of earth. There is inertia, which all times resists against redirections, e.g. produces centrifugal forces within any rotor system. There are magnetic forces, so e.g. unlike poles of permanentmagnets attract each other. There are balancing forces, e.g. effecting same level of heat within neighbouring areas. There are charges e.g. within atmosphere or within electric elements, with tendency to equal spreading. There are chaotic movements, e.g. molecular movements which after some ordered flux will fall back to chaotic movements.
All theses forces of Free Energy want to achieve a certain status, e.g. most deep level, most large radius, best possible approach or equal spreading.
Regenerator
These forces of Free Energy are to use within a regenerator-unit, which in principle shows two phases. So a regenerator always is a pulsating system, which takes two different status alternately. System must force, one phase is following the other, e.g. while one mechanical turning or within any other steady circuit.
Within working-stroke, original status above is disturbed, e.g. mass is lifted, mass is pulled to smaller radius, unlike poles are put off each other, different tempertures or pressures or densities in neighbouring areas are produced.
Within regeneration-stroke, this unit must allow forces of Free Energy to reproduce original status. As a rule, this is done by giving free posibility of movement, e.g. by mechanic gear or by valves or rectifiers or any usefull measures.
Coupling
Work-stroke within regenerator with its modification of status demands input of power, cause this change is done versus steady given force of Free Energy.
Force demanded by this work-stroke of regenerator is to take from outside. There are necessary any mechanical or hydraulic or electromechanic or electromagnetic or any other conneting elements, by which this energy-transfere technically can be done.
Generator
Demanded power is produced within a second unit, as there is done workload of any kind. Each work is done versus some resistance. Within an electric generator e.g. workload of producing electric flux is done, magnet will show resistance while moving alongside coil. Within a water pump e.g. work is done by moving water, and weight or inertia of water will resist. This resistance is give at any kind of ´consumer´.
Resistance of work-stroke of generator technically is bound by coupling above to resistance of work-stroke of regenerator.
Double workload
By forced control of regenerator, its work-stroke is started and this phase will demand input of power, which is drawn off generator. By this process, also within generator work is done, resulting any kind of modification of status. If this changed status within generator is wanted or sensefull or usefull result, then some benefit is achieved resp. really generated.
Work-strok of regenerator doesn´t serve for immediate purpose. Modification of status is equalized by following regeneration phase completely. In total, thus regenerator by itself doesn´t produce lasting work, but repeatedly will offer possibility of resistance. If several moduls within regenerator work phase-shifted, this unit will also be able to offer permanent resistance, e.g. by steady given turning momentum.
Service-Unit
Regenerator as a rule demands input of power for starting of system, also permanently will exist losses by friction. If an autonomous system shall be constructed, some part of energy-turnaround must be drawn off for service unit, which will be e.g. an electric motor / generator plus accumulator.
Example Sunwheel-Motor
Sunwheel-Motor is a pure mechanically working regenerator. Within a rotor system all masses turn steady at idle motion. Finally when workload of a consumer-unit, e.g. an electric generator, is charged at output of regenerator, a crank-shaft is delayed relative to system turning speed. By this process is forced pulsation movements of rotor masses.
At work-stroke, masses are pulled inwards versus centrifugal forces, thus demanded power (partly) serves for overcome of resistance within generator, while generator produces its useful result of its work-stroke. Within following regeneration phase of regenerator, crank-gear allows free available inertia resp. centrifugal forces to re-establish original status. If several moduls within regenerator are working phase-shifted, permanent turning momentum at output shaft is available.
Unlimited versions
This principle is usable at all forms of Free Energy mentioned above, probably also e.g. at chemical processes. When using each of these forces, lots of technical variations are possible. So within short time, probalbly many Perpetuum Mobile third kind will come up - and some probably work already by this or similar principles, e.g. well known heat pumps.
Ether-vortice and pollution
In reality, there is only one kind of material matter, quintessence of ether. All other occurances of material or physical kind, but also of mental and spiritual kind, are ´only´ very complex patterns of ether movements. There are no parts nore particles at all, but anything is bound to anything directly, at basis of all including ether movements. By Ether-Theory, I already mentioned some properties and effects of ether, however I soon will present quite new version of.
Thus all forces mentioned above are also special patterns of ether movements. One has to take care, not to disturbe and pollute unnecessaryly ether movements by technical vortices. Already today, this occures irresponsibly e.g. by electromagnetic radiation of any kind. So, of unlimited possibilities of Perpetuum Mobile third kind, only these should be used with most small side effects. These are pure mechanical systems, while electromagnetic or electronic processes are used a lot, but knowledges about real effects of these systems are rather small.
Economy and ethics
Perpetuum Mobile third kind will be used at many subjects and naturally will also have economic importance. For example, energy supply will be available by low costs and thus some dependences will be reduced.
Much more important changes however, already occured at economy, based on slogans like globalization, global players, shareholder-value or finance markets. By these ´Perpetuum Mobile of fourth kind´, by financial transactions and exploitation, few super-rich and super-mighty clans are able to dictate events at this globe in total, as they like it. In addition, by lobby they have influence on politics and by media-concentration onto all people. Parallel to these changes, at many subjects came up some culture of ´cleverness´, lastly common experiment to live on other´s costs.
Fortunately, ´Perpetuum Mobile of fifth kind´ seams to come up: conviction of many people, anything is depending on anything indeed (by pure matter, see ether above), ethics are not strange customs but in own best interests, life will only make sense by social, mental and spiritual developement of each person. So there is cause for hope, right kind of movements will overcome.
Evert / 28.06.2002
| Appendix Perpetuum Mobile | Perpetuum Mobile | Index / Sitemap |